金沙官网

欢迎光临金沙网站建筑装饰工程有限公司 ! 收藏网站收藏网站 在线留言在线留言 联系我们联系我们

富美家中国战略合作伙伴 C CTV专访品牌
产品/加工技术热线: 18560211715
0531-85925226
大家都在搜:
您的位置: 首页 > 新闻动态>>富美家告诉大家粉状防火材料怎么去施工

富美家告诉大家粉状防火材料怎么去施工

来源:/ 日期:2020-03-12
     1. 无机保温材料和设备(以下评论WW绝缘材料,例如)的基础上,不同地区,不同季节,不同的气候特点,不同湿度的空气和底部墙材料按照“WW”无机保温材料和水重约1.5:1,放在搅拌机搅拌3 - 5分钟的操作。初始设置时间约为2小时。
  1. On the basis of inorganic insulation materials and equipment (WW insulation materials are commented below, for example), air and bottom wall materials with different humidity in different regions, seasons and climatic characteristics shall be mixed in the mixer for 3-5 minutes according to the weight of "WW" inorganic insulation materials and water of about 1.5:1. The initial setting time is about 2 hours.
  2. 无机保温材料的应用
  2. Application of inorganic thermal insulation materials将底层墙体清洗干净并粘湿(如混凝土等光滑墙体需提前一天做常用的界面砂浆抛撒处理),将拌好的“WW”保温隔热材料直接批量上底层墙体或抹上水泥砂浆。次统一的密度将覆盖墙为主,厚度掌握在10分钟左右,当次信息的含水量约为50%,可以第二次批,批厚度可以掌握在10 - 20分钟,直到达到计划要求厚度。到达粘结牢固,不空鼓,不开裂。
富美家
  Clean and wet the bottom wall (for example, the smooth wall such as concrete needs to be sprinkled with common interface mortar one day in advance), and apply the mixed "WW" heat insulation materials directly to the bottom wall or cement mortar. The first uniform density will mainly cover the wall, and the thickness will be controlled in about 10 minutes. When the water content of the first information is about 50%, the second batch can be used, and the batch thickness can be controlled in 10 - 20 minutes, until the planned thickness is achieved. To achieve a firm bond, no hollowing, no cracking.
  一般保温材料的施工厚度在20mm -25mm之间可以一次性成批完成,保温材料的厚度在30mm -40mm之间可以第二批完成,也可以按外一内二复合保温。所有的工序在一天结束后,7天后可以贴砖,10天后可以做涂饰。施工周期比任何其他保温系统节省一半以上。节省工艺,节省时间,节省成本,工期短,效率高。
  Generally, the construction thickness of thermal insulation materials can be completed in batches at one time between 20 mm and 25 mm, and the thickness of thermal insulation materials can be completed in the second batch between 30 mm and 40 mm, as well as the external internal composite thermal insulation. All processes can be tiled after 7 days and painted after 10 days. The construction period is more than half of that of any other insulation system. Save technology, save time, save cost, short construction period and high efficiency.
  3.质量检验
  3. Quality inspection
  底部墙体达到相关规范要求,保温层厚度和结构应符合规划要求,且结构层之间要牢固粘结,无分层、无空鼓、无裂缝等现象。孔、线槽、线箱、管道穿墙后的零件处理应做到:刻度准确、边缘规整、线角和灰线笔直、清晰美观。
  The bottom wall shall meet the requirements of relevant specifications, the thickness and structure of the insulation layer shall meet the planning requirements, and the structural layers shall be firmly bonded without layering, hollowing, cracks and other phenomena. The parts of holes, trunking, trunking and pipes passing through the wall shall be treated as follows: accurate scale, regular edge, straight line angle and gray line, clear and beautiful.
  4. 预防措施
  4. Preventive measures
  1)“WW”无机保温材料在现场施工时,不需要添加任何其他材料和物品,以保证产品质量。
  1) "WW" inorganic thermal insulation materials do not need to add any other materials and articles to ensure the quality of the products during the construction on site.
  2)“WW”保温材料在制备过程中即加水搅拌后使用。一般在2小时左右用完,第二天或干固后不得再用,以免影响质量。
  2) "WW" insulation material is used after mixing with water in the preparation process. It is generally used up in about 2 hours, and shall not be reused the next day or after dry consolidation, so as not to affect the quality.
  3)无机保温材料不应低于5℃在冬季或在24小时内完成后壁保温工程,环境空气温度不应低于5℃,在冬天应防止阳光照射在夏天,温度超过25℃时,需要正确的维护,5级以上风和雨天不得建造。
  3) Inorganic thermal insulation materials shall not be lower than 5 ℃ to complete the rear wall thermal insulation project in winter or within 24 hours, and the ambient air temperature shall not be lower than 5 ℃. In winter, sunlight shall be prevented from shining in summer. When the temperature is higher than 25 ℃, proper maintenance is required, and it is not allowed to build in wind and rain above level 5.
  做好产品维护,对施工后的墙面,防止雨后磕碰,坚持施工现场通风干燥。每次施工结束后要及时清理施工物品和搅拌机具,以免影响下次使用。
  Do a good job in product maintenance, prevent bumping on the wall after construction, and adhere to the ventilation and drying on the construction site. At the end of each construction, the construction materials and mixing machines and tools shall be cleaned in time to avoid affecting the next use.
  以上是富美家小编为大家介绍的相关内容,想要了解更多内容,欢迎访问网站:The above is the related content introduced by Fujia. If you want to know more, please visit the website: http://www.fumijia.net

全国服务热线

18560211715
XML 地图 | Sitemap 地图